JAX: Feedback on automatic lock when safety lock is active

Confirmation: Automatic lock enabled when safety lock is active

Problem

The automatic lock feedback in JAX is equivalent to "an automatic (tile) is locked." This leads to the following problems:
1. When using the RGB feedback signals "Safety Lock" (red) and "Automatic Lock" (blue) on a single LED, an alarm first displays red (Safety Lock) and shortly thereafter blue (Automatic Lock).
2. If the "Safety Lock" and "Automatic Lock" feedback signals are displayed on two different LEDs, both will light up when the safety lock is active.

Workaround

The firmware must be updated to version 2.1 or higher. Starting with version 2.1, the "Automatic Lock" feedback indicates that "an automatic (tile) is locked; the lock is not a safety lock." This behavior is now consistent with that of the MSX.
For a DCA configuration, DCA version 2.1 must also be installed.

Occurs in version

• .1.X.2.0
• 397.1.X.1.X