If the brightness falls below or exceeds the threshold, the brightness control command is issued again
Problem
If the switch-off delay has not yet elapsed, the "On_active" state is maintained. When light, no light state is generated, and consequently no light drive command is issued. If no switch-off time is stored for VZDP, a drive command is issued randomly or not at all, but the Off state (Off_active) is reached immediately. When it is light, a drive command is issued again, which is therefore difficult to understand.
Workaround
VZDP1=VZDP2 should be greater than Dark1=Dark2.
Occurs in version
- 129.V1.x.V1.18
- 298.V1.x.V1.19
- 326.V1.x.V1.20
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article